Click the button below to download the firmware for MHS-FS3

MHS-FS3.BIN 【File size：25.9MB（27,187,200bytes）】

- Please store the downloaded-file “MHS-FS3.BIN” on the desktop(recommended) of your computer.

• Connect the camera to the computer with the USB connection support cable (supplied)
  - “USB Mode/Mass Storage” will be displayed on the LCD screen.
  
  
  
• The computer will detect two drives below. (Alphabets for drives depend on the computer environment.)
  - “BLOGGIE“
  - “BLOGGIE_SW“
• If LUN Settings is set to “Single”, the computer will detect just one drive of BLOGGIE.

• The drive which has smaller alphabet such as “BLOGGIE“ of ‘2. Connect the camera to the computer’ is the internal memory of the camera.
  - If LUN Settings is set to “Single”, the detected drives is the internal memory.
• Double-click the icon of the drive of “BLOGGIE” to open.
• Copy the downloaded file to that drive.
  For MHS-FS3 user, the file will be “MHS-FS3.BIN”
• Disconnect the camera with the computer by the procedure below
  - Drag and drop the icon of the drive to the "Trash" icon before disconnecting.
• Disconnect the USB connection support cable from the camera

• Confirm whether the battery icon at the upper-right corner of the LCD screen is full.
• Press the “ON/OFF” button to power off.
• Press the “ON/OFF” button again to power on.
• Updating firmware will start automatically.
  - You can see animation of “...” in the message of “Updating...” on the LCD screen.
  
  
  
• After 30 seconds, the camera will shutdown automatically.
  

  		Don’t turn off the camera while updating firmware, or the camera may be damaged.